Relay_16 not loaded?

[hamhog]

Did you enable the relay plugin after installing it? That would be under plugins > Manage Plugins. There should be a check in the box under Enabled next to the name of the plugin.

And I am guessing that you saw the diagram on the plugin's help page. That shows which GPIO pins relate to each relay.
That would be under Plugins > Relay 16 > help

Thanks for the reply Dan.
Yes the relays are enabled but I just restarted SIP and now my relay attached to GPIO 22 (S02) is working and I found
by accident that GPIO 17 which I have an LED attached for previous test not with SIP now toggles using manual control S01
which from some other diagram here shows GPIO 18. I am using a Sprkfun Wedge that goes from the 40 pin Pi connector to a breakout
that is easy to prototype with. There was an image about the GPIO 40 pin connector and how that mapped to relay pins but i can't find it now (as usual!). I am sure it showed pin 18 for S01 but now I can't confirm that.

2 other issues. First when watching the terminal screen on the Pi I see the last IP address as 192.168.0.18 but today the Pi got the address 192.168.0.15 so i am puzzled why that didn't update watching terminal window on the Pi.
Second is when ever i change anything and I have to update or reset and a window would open and say I have to reset via terminal window. Well now trying verify this again it didn't happen as previous times.
Thanks,
Bruce
Under plugins and then relay channels are not relay channels for me. If I select 1 then I can toggle S01 but not S02, when i change channels to 2 then I can toggle both S01 and S02.

Ok so i found the image Relay_16-connect.png you show pin 18 as station 1 and I think that's not right and should be pin 17