2020 Jun 09, 08:03 PM
(This post was last modified: 2020 Jun 09, 08:12 PM by HereComesTheRain.)
(2020 Jun 09, 06:18 PM)astrogerard Wrote: Hope this helps a little :-)
It's a big help!
I have a 5v 8amp and a 5v 3amp power supply I will try.
So I will bring in power to the perfboard or breadboard and the feed the relays from there.
Any issues or precautions to take to prevent over-voltage to the relays or to the valves?
Thanks again for your time and assistance.
(2020 May 30, 03:42 PM)dan Wrote: You should be able to get all the parts....
Hi Dan.
Could I get some clarification on the parts listed below as to what to order exactly.
[*]a few pin headers
[*]a 10k Ohm resistor
[*]a 0.1 microfarad capacitor (optional)
Thanks.