Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Valve turns on at the end of program and off at the beginning of next scheduled
#2
Look at the setting at Options > Station handling > Active-Low Relay

If it has a check mark uncheck it. This setting reverses the logic of the controller. It sends an "off" signal instead of an "on" signal.
Reply


Messages In This Thread
RE: Valve turns on at the end of program and off at the beginning of next scheduled - by dan - 2017 Dec 02, 03:55 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)