2017 Jul 19, 06:21 PM
Hi SIP community.
I am having the following problem with the SIP library/interface:
- The SIP interface starts and it works ok for a while (very short while).
- After running some few programs (automatic or Run Once), this problem happens: a program is scheduled and appears scheduled in the home page (e.g.: Run Once 30 seconds) and stays there frozen: it doesn't start the station and it doesn't start the count down either. See image attached.
- If the the "Stop all stations" is pressed, the station is cleaned. But not even scheduling again and again will activate the station!!
- The only way to get the programs running again is rebooting the RPi.
- And same story: few programs run (usually less than 10 times) and then the station is frozen.
Has anyone experienced the same or similar? or may have a clue what is the issue?
Many thanks.
elongo!!
I am having the following problem with the SIP library/interface:
- The SIP interface starts and it works ok for a while (very short while).
- After running some few programs (automatic or Run Once), this problem happens: a program is scheduled and appears scheduled in the home page (e.g.: Run Once 30 seconds) and stays there frozen: it doesn't start the station and it doesn't start the count down either. See image attached.
- If the the "Stop all stations" is pressed, the station is cleaned. But not even scheduling again and again will activate the station!!
- The only way to get the programs running again is rebooting the RPi.
- And same story: few programs run (usually less than 10 times) and then the station is frozen.
Has anyone experienced the same or similar? or may have a clue what is the issue?
Many thanks.
elongo!!