2017 May 29, 09:40 PM
I just set up SIP with a Raspberry Pi 3 and the TIAO Smart Sprinkler Pi v2.0 board. It is one of the best projects I've used with the Pi. Thank you.
My question has to do with the rain sensor setup. The TIAO board has a Rain Sensor hookup on pins 5 & 6 of the small external connector. Can the SIP Software read these pin and use the status with the default SIP Software. Right now I am not seeing any change in status within the SIP application when Pins 5 & 6 change state.
Can you shed some light on how to use my rain sensor (Rain Bird)? Will I have o wire it directly to BCM 14 and Ground?
Thank you again for such a fine product.
My question has to do with the rain sensor setup. The TIAO board has a Rain Sensor hookup on pins 5 & 6 of the small external connector. Can the SIP Software read these pin and use the status with the default SIP Software. Right now I am not seeing any change in status within the SIP application when Pins 5 & 6 change state.
Can you shed some light on how to use my rain sensor (Rain Bird)? Will I have o wire it directly to BCM 14 and Ground?
Thank you again for such a fine product.