Associate pins to stations? (newbie Q)
|
Associate pins to stations? (newbie Q)
|
2022 Aug 30, 08:19 AM
(2022 Aug 30, 07:19 AM)astrogerard Wrote: A dim glow means that the gpio pin of the Pi is not configured for output. Either the SIP program hasn't started (yet) or it is connected to a non-output pin. This is not "bad" for the Pi but it can result in unwanted (in)active relays and/or valves. Thank you for your reply. Is there any point in configuring all the pins and setting them to "off" before (or after) SIP starts? |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Associate pins to stations? (newbie Q) - by noequus - 2020 Nov 26, 11:34 PM
RE: Associate pins to stations? (newbie Q) - by dan - 2020 Nov 27, 03:15 PM
RE: Associate pins to stations? (newbie Q) - by noequus - 2020 Nov 30, 07:43 PM
RE: Associate pins to stations? (newbie Q) - by dan - 2020 Dec 01, 03:46 PM
RE: Associate pins to stations? (newbie Q) - by noequus - 2020 Dec 04, 11:35 PM
RE: Associate pins to stations? (newbie Q) - by nanogeek - 2022 Aug 29, 04:10 PM
RE: Associate pins to stations? (newbie Q) - by dan - 2020 Dec 05, 03:39 AM
RE: Associate pins to stations? (newbie Q) - by astrogerard - 2022 Aug 30, 07:19 AM
RE: Associate pins to stations? (newbie Q) - by nanogeek - 2022 Aug 30, 08:19 AM
RE: Associate pins to stations? (newbie Q) - by astrogerard - 2022 Aug 30, 01:21 PM
|
