2016 May 07, 08:41 AM
Thanks, I read the source code and informed in internet about pin Numeration physical and BCM of raspberry and and seem a bit complicated... 
anyway I thought about the pin 8 , just I seen is also for UART so I was not sure. So you means the contact should be from physical 8 and ground?
Anyway yesterday I tried the system with 6 valve sistem, and relay board saint smart. The system work , in manual all valve can be in drived.
Just a problem I noticed that if I make a single pass program, anyway the system generate a recurrent program even in the json file and anyway it doesn't run.
Also I noticed a very slow connection with android mobile now that system is isolated (not connected to internet) this can be generate some problem? I will go through further testing next days and will let you know results. Thanks!
anyway I thought about the pin 8 , just I seen is also for UART so I was not sure. So you means the contact should be from physical 8 and ground?Anyway yesterday I tried the system with 6 valve sistem, and relay board saint smart. The system work , in manual all valve can be in drived.
Just a problem I noticed that if I make a single pass program, anyway the system generate a recurrent program even in the json file and anyway it doesn't run.
Also I noticed a very slow connection with android mobile now that system is isolated (not connected to internet) this can be generate some problem? I will go through further testing next days and will let you know results. Thanks!