2016 May 06, 11:10 PM
I am new to sprinklers and SIP, so this is probably my mistake, but i can't figure it out. I have been trying to get my new system setup. It is one zone feeding a drip irrigation system right now. I can't figure out what is happening. With the hardware off the valve is closed. When boot up the Pi the water stays off. That makes sense, but when I then do a 'run once' for say 30 seconds the system stays off, then when the 30 seconds is up the system comes on (the status in SIP says OFF). If I do a 'run once' for another 30 seconds it turns off when the program starts and turns on when it ends. If I then select 'system off' it turns the water off.
The valve I am using is an Irritrol 2500T (http://www.sprinklerwarehouse.com/Irritr.../2500t.htm)
Any thoughts on what might be happening?
The valve I am using is an Irritrol 2500T (http://www.sprinklerwarehouse.com/Irritr.../2500t.htm)
Any thoughts on what might be happening?