2021 Jun 29, 07:59 PM
(This post was last modified: 2021 Jul 09, 07:39 PM by astrogerard.)
3.3v instead of 5v is just to try to see if the problem is still there, the led's will be a bit less bright but you will still see them.
For connecting the resistors I made a (very quick) drawing which I will attach. Hopefully you can get the idea.
Only 1 pull-up resistor is needed (so not on all hc595')
The 0.1 + 47uF should be as close as possible to the circuit and with short as possible wires. I would also put one on the connector plug adapter on where you connect the breadboard wires.
A personal note: Tomorrow I have to undergo a small operation so I might be offline for a few days.
--Gerard
** EDIT ** !!! Error in attached drawing: Label Pi_14 is wrong, should be Pi_13 !!!
For connecting the resistors I made a (very quick) drawing which I will attach. Hopefully you can get the idea.
Only 1 pull-up resistor is needed (so not on all hc595')
The 0.1 + 47uF should be as close as possible to the circuit and with short as possible wires. I would also put one on the connector plug adapter on where you connect the breadboard wires.
A personal note: Tomorrow I have to undergo a small operation so I might be offline for a few days.
--Gerard
** EDIT ** !!! Error in attached drawing: Label Pi_14 is wrong, should be Pi_13 !!!