Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Connecting Pi4 to OSPI board using Rainbow cable
#4
(2020 Jun 17, 04:50 PM)JTup Wrote: Thanks Dan. 

Case looks great. I'd prefer not to have the fan noise also. 

How would you expose the GPIO pins with Flirc case? Do you leave the roof off?
There is a slot in the bottom of the case for the wires to come out. The case has rubber feet that allow room for the wires.

The top of the case has a piece that contacts the top of the Pi's processor chip through a heat conducting pad. That is why the case can act as a heat sink.
<p><br></p>
Reply


Messages In This Thread
RE: Connecting Pi4 to OSPI board using Rainbow cable - by dan - 2020 Jun 17, 11:32 PM

Forum Jump:


Users browsing this thread: 2 Guest(s)