New setup with relay_board plugin

[INSANESNWBRDR@GMAIL.COM]

im having issues with the relay_board plugin.

the config is setup as ACTIVE LOW with 12 relays

every relay is constant LOW meaning active and i cannot get them to activate or change.

if i change the number of relays in the plug setting and restart SIP the active relays will change to the number set in config.  ie if i set it as 1 the number 1 relay goes active if 12 the first 12 on the board go on.

the setup is a PI 3 and 16 channel relay board with its own external power.

[dan]

What happens if you set the relay_board config to active High?

[INSANESNWBRDR@GMAIL.COM]

What happens if you set the relay_board config to active High?

Same makes no difference.  The board is active low and trips correctly when jumped to ground.

[dan]

When you say jumpered to ground do you mean adding a jumper wire from ground on the relay board to ground on the Pi?

Is it then working correctly?

[INSANESNWBRDR@GMAIL.COM]

Just verifying that the board correctly activates the relay when the driver pin is grounded

[dan]

I just received a Pi 3 and verified that the relay_board plugin works with it.
I don't have a 16 channel relay board to test with so I am not able to reproduce the problem you are having.

I'm guessing you have double checked the wiring.